Product Catalog — 1700mm Strip Mill

Hot Rolled Products

Precision hot rolled carbon steel coils, sheets, strips, and plates engineered for heavy fabrication and structural applications.

Overview & Applications

Hot rolled carbon steel coils, sheets, strips, and plates are produced at Pakistan Steel's state-of-the-art 1700mm Hot Rolling Strip Mill, meeting stringent dimensional and metallurgical requirements.

Primary Industrial Uses:

Seam welded pipes for Gas, Water, and Oil transmission.
Storage tanks, pressure vessels, and industrial containers.
Ships, barges, launches, and floating marine structures.
Fabricated structural steel sections and heavy engineering.
General purpose commercial sheets and plates.
Automotive wheel rims.
Cold-formed sections, steel flooring, and feedstock for Cold Rolled products.

Standard Dimensions

Standard Sizes of Hot Rolled Sheets — As Rolled Edges (mm)

Thickness (mm)	Min. & Max. Sheet Lengths per Width (W)
Thickness (mm)	1000 (W)	1220 (W)	1500 (W)
1.6, 2.0	2440	2440	-
2.35	-	2440	-
2.65, 2.90	2440	2440	-
3.25, 3.65	2440	2440, 6000	2440, 3000, 6000
3.90, 5.0, 6.0	2440, 6000	2440, 6000	2440, 3000, 6000
7.0, 8.0, 9.0, 10.0, 12.0	2440, 6000	2440, 6000	2440, 3000, 6000

Standard Sizes of Hot Rolled Coils

Width As Rolled (mm)	Thickness of Hot Rolled Coils (mm)
1000 & 1220	1.6, 2.0, 2.35, 2.65, 2.90, 3.25, 3.65, 3.9, 4.0, 4.5, 5.0, 6.0, 6.5, 7.0, 8.0, 9.0, 10.0, 12.0
1500	2.90, 3.25, 3.65, 3.9, 4.0, 4.5, 5.0, 6.0, 6.5, 7.0, 8.0, 9.0, 10.0, 12.0

Supply Notes:

Hot rolled carbon steel coils can be supplied in custom dimensions (width and thickness) for substantial order quantities.
Thicknesses from 1.6mm to 6.0mm can also be supplied in a pickled and oiled state upon mutual agreement.
H.R. sheets/coils with trimmed edges will be 50mm narrower than the rolled-edge width.

Quality Tolerances & Edge Standards

Allowable Telescopicity in Hot Rolled Coils

Thickness (mm)	Width (mm)	Telescopic Value (mm)
Up to & Incl. 2.5	Up to & Incl. 800	50
Up to & Incl. 2.5	Over 800	100
Over 2.5	Up to & Incl. 800	35
Over 2.5	Over 800	70

* Coils having one inner or outer ring protruding above the coil edge are not considered telescopic. Loosening of up to two outer rings is acceptable and not grounds for rejection.

Edge Condition

Cracks or torn edges on mill edges shall remain within one-half of the width tolerance. Local bent edges at an angle of 90° or less are permitted.

Camber Tolerances for Coils & Cut Lengths

Coils: Maximum 25mm in any 5000mm length.
Cut Sheets: Maximum 0.5% × total sheet length.